Rose-GUIDE
  • SETUP INSTRUCTIONS
    • Windows reinstall
      • Valorant reinstallation
        • Using Rufus to Create a Bootable USB
        • Boot On USB
        • Cleaning Disks Command Prompt
        • Windows Setup
        • Disable Windows Defender
        • Disable Windows Updates
        • Turn Off WiFi & Bluetooth [Required]
      • Normal reinstallation
        • Using Rufus to Create a Bootable USB
        • Boot On USB
        • Cleaning Disks Command Prompt
        • Windows Setup
        • Disable Windows Defender
        • Disable Windows Updates
        • Turn Off WiFi & Bluetooth [Required]
    • Bios Flashing
      • Bios Configuration
      • Disable and Enable Features
    • Loader Download
  • VGC/VGK [Valorant, etc]
    • Permanent Spoof
      • TMAC
      • DISABLE IPV6
    • New Account[Imporant]
    • 🎉End of Spoofing
  • EAC/BE [FORTNITE, ETC]
    • Permanent Spoof
      • TMAC
      • DISABLE IPV6
    • New Account[Imporant]
    • VPN
  • Valorant Setup
    • inject
  • Fortnite Private Setup
    • inject
  • TPM spoofer
Powered by GitBook
On this page
  1. SETUP INSTRUCTIONS
  2. Windows reinstall
  3. Valorant reinstallation

Cleaning Disks Command Prompt

Your Flash Drive is likely the last drive listed (DO NOT DELETE IT)

PreviousBoot On USBNextWindows Setup

Last updated 3 months ago

  1. Open Command Prompt

    • Press SHIFT + F10 to open the Command Prompt during the Windows installation process.

  2. Launch Diskpart

    • Type diskpart and press Enter to start the Disk Partition tool.

  3. List Available Disks

    • In Diskpart, type list disk and press Enter to view all available drives.

  4. Select and Clean Disks

    • For each disk except your USB flash drive:

      • Type select disk # (replace # with the disk number from the list).

      • Type clean and press Enter to delete all data on the selected disk.

    Important: Your USB flash drive is likely the last drive listed. Do not clean this drive.

  5. Close and Refresh

    • Close the Command Prompt.

    • Click Refresh in the Windows installer to update the available disk list.

Once this process is complete, you can proceed with the Windows installation.

  1. Close the CMD and click Refresh

  1. Select your main drive and click Next The installation process should start

⚠️